Displaying And Maintaining Device Management Configuration - H3C S3610 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S3610&S5510 Series Ethernet Switches
Table 3-4 Follow the step below to clear the 16bit interface indexes not used in the
current system
Clear the 16bit interface indexes
not used in the current system
Caution:
A confirmation is required when you carry out this command. If you fail to make a
confirmation within 30 seconds or enter "n" to cancel the operation, the command will
not be carried out.
3.4 Displaying and Maintaining Device Management
Configuration
After the above configuration, you can use the display command in any view to display
the operation status of the device, so as to verify the configuration effect.
Table 3-5 Display and maintain device management configuration
Display the BootROM file
used for the next boot.
Display the statistics of
the CPU usage
Display information about
storage media on the
device
Display
state of fans in a device
Display the usage of the
memory of a device
Display the power state of
a device
Display the reboot time of
a device
To do...
To do...
display boot-loader
display cpu-usage [ number [ offset ]
[ verbose ] [ from-device ] ]
display device [ manuinfo | subslot
subslot-number | verbose ]
the operating
display fan [ fan-id ]
display memory
display power [ power-id ]
display schedule reboot
Use the command...
reset unused porttag
Use the command...
3-20
Chapter 3 Device Management
Remarks
—
Remarks
Available
in
view
any