Setting To Output System Information To The Console - H3C S3100-52P Operation Manual

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch

1.2.4 Setting to Output System Information to the Console

I. Setting to output system information to the console
Follow these steps to set to output system information to the console:
Enter system view
Enable the information
center
Enable system
information output to the
console
Configure the output rules
of system information
Set the format of time
stamp in the output
information
Note:
To view the debugging information of some modules on the switch, you need to set the
type of the output information to debug when configuring the system information output
rules, and use the debugging command to enable debugging for the corresponding
modules.
To do...
system-view
info-center enable
info-center console
channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Use the command...
1-10
Chapter 1 Information Center
Remarks
—
Optional
Enabled by default.
Optional
By default, the switch
uses information channel
0 to output
log/debugging/trap
information to the
console.
Optional
Refer to Table 1-4 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is
boot.