Setting To Output System Information To The Console - H3C S3100 Series Operation Manual

Operation
Set the time stamp
format in the output
direction of the
information center to
date
Set to display the UTC time zone in the
output information of the information
center

Setting to Output System Information to the Console

Setting to output system information to the console
Table 1-7 Set to output system information to the console
Operation
Enter system view
Enable the information center
Enable system information
output to the console
Configure the output rules of
system information
Set the format of time stamp in
the output information
To view the debugging information of some modules on the switch, you need to set the type of the
output information to debug when configuring the system information output rules, and use the
debugging command to enable debugging for the corresponding modules.
Log host info-center timestamp loghost
direction date
Non log host info-center timestamp { log | trap
direction | debugging } date
info-center timestamp utc
Command
system-view
info-center enable
info-center console channel
{ channel-number | channel-name }
info-center source { modu-name |
default } channel
{ channel-number | channel-name }
[ { log | trap | debug } { level
severity | state state } ]*
info-center timestamp { log | trap
| debugging } { boot | date |
none }
Command
—
Optional
Enabled by default.
Optional
By default, the switch uses information
channel 0 to output
log/debugging/trap information to the
console.
Optional
Refer to
output rules of system information.
Optional
By default, the time stamp format of
the log and trap output information is
date, and that of the debugging output
information is boot.
1-8
Description
Required
Use either command
Required
By default, no UTC time
zone is displayed in the
output information
Description
Table 1-8 for the default