Virtual Router Redundancy Protocol Commands; Ip Vrrp (Interface Config) - NETGEAR M6100 Series Reference Manual

Virtual Router Redundancy Protocol Commands

This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default none
Format
ip vrrp
Mode Global Config
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of
VRRP on the router.
Format
no ip vrrp
Mode Global Config

ip vrrp (Interface Config)

Use this command in Interface Config mode to create a virtual router associated with the
interface or range of interfaces. The parameter vrid is the virtual router ID, which has an
integer value range from 1 to 255.
Format
ip vrrp vrid
Mode Interface Config
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the
interface. The virtual Router ID, vrid, is an integer value that ranges from 1 to 255.
Format
no ip vrrp vrid
Mode Interface Config
M6100 Series Switches
Routing Commands
683