Dot1X Unauthenticated-Vlan - NETGEAR M6100 Series Reference Manual

Tokens Definition
tx-period The value, in seconds, of the timer used by the authenticator state machine on this port to determine
when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period must be a
value in the range 1 - 65535.
supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to timeout
the supplicant. The supp-timeout must be a value in the range 1 - 65535.
server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to timeout
the authentication server. The supp-timeout must be a value in the range 1 - 65535.
Default guest-vlan-period: 90 seconds
reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
Format
dot1x timeout {{guest-vlan-period seconds} |{reauth-period seconds} |
{quiet-period seconds} | {tx-period seconds} | {supp-timeout seconds} |
{server-timeout seconds}}
Mode Interface Config
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port to the default values. Depending on the token used, the corresponding
default values are set.
Format
no dot1x timeout {guest-vlan-period | reauth-period | quiet-period |
tx-period | supp-timeout | server-timeout}
Mode Interface Config

dot1x unauthenticated-vlan

Use this command to configure the unauthenticated VLAN associated with the specified
interface or range of interfaces. The unauthenticated VLAN ID can be a valid VLAN ID from
0–maximum supported VLAN ID (4093 for NETGEAR Managed Switch). The
unauthenticated VLAN must be statically configured in the VLAN database to be operational.
By default, the unauthenticated VLAN is 0, i.e. invalid and not operational.
Default 0
Format
dot1x unauthenticated-vlan vlan-id
Mode Interface Config
M6100 Series Switches
Switching Commands
403