Show Port-Security Dynamic - NETGEAR M6100 Series Reference Manual

Format
show port-security [unit/slot/port | all]
Mode Privileged EXEC
Term Definition
Admin Mode Port Locking mode for the entire system. This field displays if you do not supply any parameters.
For each interface, or for the interface you specify, the following information displays.
Term Definition
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Whether violation traps are enabled.
Mode
Sticky Mode The administrative mode of the port security Sticky Mode feature on the interface.
Command example:
(NETGEAR Routing) #show port-security 0/1
Admin Dynamic
Intf Mode Limit
------ ------- ----------
0/1 Disabled 1

show port-security dynamic

This command displays the dynamically locked MAC addresses for the port. Instead of
unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the
LAG interface, in which lag-intf-num is the LAG port number.
Format
show port-security dynamic unit/slot/port
Mode Privileged EXEC
Term Definition
MAC Address MAC Address of dynamically locked MAC.
M6100 Series Switches
Static Violation
Limit Trap Mode
--------- ---------
1 Disabled
Switching Commands
540
Sticky
Mode
--------
Enabled