Show Ip Ospf Stub Table; Show Ip Ospf Traffic - NETGEAR M6100 Series Reference Manual

00:04:50 0
00:04:46 0
00:03:42 0
00:03:39 0
00:03:36 0
00:01:28 0
00:01:25 0
00:01:22 0
00:01:19 0
00:01:16 0

show ip ospf stub table

This command displays the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
Format
show ip ospf stub table
Modes Privileged EXEC
User EXEC
Term Definition
Area ID A 32-bit identifier for the created stub area.
Type of Service The type of service associated with the stub metric. NETGEAR supports only Normal TOS.
Metric Val The metric value is applied based on the TOS. It defaults to the least metric of the type of service
among the interfaces to other areas. The OSPF cost for a route is a function of the metric value.
Import Summary Controls the import of summary LSAs into stub areas.
LSA

show ip ospf traffic

This command displays OSPFv2 packet and LSA statistics and OSPFv2 message queue
statistics. Packet statistics count packets and LSAs since OSPFv2 counters were last
cleared (using the command
Note: The clear ip ospf counters
queue high water marks.
Format
show ip ospf traffic
Modes Privileged EXEC
M6100 Series Switches
60 0
90 0
70 10
70 40
60 60
60 50
30 50
0 40
0 20
0 0
clear ip ospf counters
command does not clear the message
Routing Commands
753
60 460
100 60
90 160
120 240
130 160
130 240
110 310
50 260
20 190
0 110
on page 713).
R, N
R, N
R
X
X
X
SN
SN
X
R, X