Show Ip Route Ecmp-Groups - NETGEAR M6100 Series Reference Manual

S 7.0.0.0/8 [1/0] directly connected, Null0
OIA 10.10.10.0/24 [110/6] via 5.5.5.2,
C 11.11.11.0/24 [0/1] directly connected,
S 12.0.0.0/8 [5/0] directly connected, Null0
S 23.0.0.0/8 [3/0] directly connected, Null0
C 1.1.1.0/24 [0/1] directly connected, 0/11
C 2.2.2.0/24 [0/1] directly connected, 0/1
C 5.5.5.0/24 [0/1] directly connected, 0/5
C 11.11.11.0/24 [0/1] directly connected, 0/11
S 10.3.2.0/24 [1/0] via 1.1.1.2, 0/11
Command example:
The following output indicates a truncated route:
(NETGEAR Switch) #show ip route
Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static
B - BGP Derived, IA - OSPF Inter Area
E1 - OSPF External Type 1, E2 - OSPF External Type 2
N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2
O E1 100.1.161.0/24 [110/10] via 172.20.11.100,
O E1 100.1.162.0/24 [110/10] via 172.20.11.100,
O E1 100.1.163.0/24 [110/10] via 172.20.11.100,

show ip route ecmp-groups

This command reports all current ECMP groups in the IPv4 routing table. An ECMP group is
a set of two or more next hops used in one or more routes. The groups are numbered
arbitrarily from 1 to n. The output indicates the number of next hops in the group and the
number of routes that use the set of next hops. The output lists the IPv4 address and
outgoing interface of each next hop in each group.
Format
show ip route ecmp-groups
Mode Privileged Exec
Command example:
(NETGEAR Switch) #show ip route ecmp-groups
ECMP Group 1 with 2 next hops (used by 1 route)
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 2 with 3 next hops (used by 1 route)
172.20.32.100 on interface 2/32
M6100 Series Switches
00h:00m:01s,
0/11
00h:00m:13s,
00h:00m:13s,
00h:00m:13s,
Routing Commands
646
0/5
2/11 T
2/11 T
2/11 T