NETGEAR M6100 Series Reference Manual page 641

Parameter Description
Networks The set of networks originated through a network command. Those networks that are actually
Originated advertised to neighbors are marked "active."
Neighbors A list of configured neighbors and the inbound and outbound policies configured for each.
OSPFv2 Section:
Routing Protocol OSPFv2.
Router ID The router ID configured for OSPFv2.
OSPF Admin Mode Whether OSPF is enabled or disabled globally.
Maximum Paths The maximum number of next hops in an OSPF route.
Routing for The address ranges configured with an OSPF network command.
Networks
Distance The administrative distance (or "route preference") for intra-area, inter-area, and external routes.
Default Route Whether OSPF is configured to originate a default route.
Advertise
Always Whether default advertisement depends on having a default route in the common routing table.
Metric The metric configured to be advertised with the default route.
Metric Type The metric type for the default route.
Redist Source A type of routes that OSPF is redistributing.
Metric The metric to advertise for redistributed routes of this type.
Metric Type The metric type to advertise for redistributed routes of this type.
Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes.
Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are
redistributed.
Number of Active The number of OSPF areas with at least one interface running on this router. Also broken down by
Areas area type.
ABR Status Whether the router is currently an area border router. A router is an area border router if it has
interfaces that are up in more than one area.
ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it is
redistributing any routes or originating a default route.
RIP Section
RIP Admin Mode Whether RIP is globally enabled.
Split Horizon Mode Whether RIP advertises routes on the interface where they were received.
Default Metric The metric assigned to redistributed routes.
Default Route Whether this router is originating a default route.
Advertise
M6100 Series Switches
Routing Commands
641