Time Zone Commands; Clock Set - NETGEAR M6100 Series Reference Manual

Field
SNTP Client Source Interface The interface ID of the physical or logical interface configured as the SNTP client source
SNTP Client Source IPv4
Address
Command example:
(NETGEAR Switch) #show sntp source-interface
SNTP Client Source Interface................... (not configured)

Time Zone Commands

Use the Time Zone commands to configure system time and date, Time Zone and Summer
Time (that is, Daylight Saving Time). Summer time can be recurring or non-recurring.

clock set

This command sets the system time and date.
Format
clock set hh:mm:ss
clock set mm/dd/yyyy
Mode Global Config
Parameter Description
hh:mm:ss Enter the current system time in 24-hour format in hours, minutes, and seconds. The range is hours:
0 to 23, minutes: 0 to 59, seconds: 0 to 59.
mm/dd/yyyy Enter the current system date the format month, day, year. The range for month is 1 to 12. The range
for the day of the month is 1 to 31. The range for year is 2010 to 2079.
Command example:
(NETGEAR Switch) (Config)# clock set 03:17:00
(NETGEAR Switch) (Config)# clock set 11/01/2011
M6100 Series Switches
Description
interface.
The IP address of the interface configured as the SNTP client source interface.
Utility Commands
213