NETGEAR M6100 Series Reference Manual page 1182

Table 73. OSAPI Log Messages (continued)
Component Message
OSAPI ping: sendto error
OSAPI Failed to Create Interface
OSAPI TAP Unable to open XX
OSAPI Tap monitor task is spinning on select failures –
then –
Tap monitor select failed: XX
OSAPI Log_Init: log file error - creating new log file
OSAPI Log_Init: Flash (event) log full; erasing
OSAPI Log_Init: Corrupt event log; erasing
OSAPI Failed to Set Interface IP Address – or – IP
Netmask – or – Broadcast Address – or – Flags –
or – Hardware Address – or –
Failed to Retrieve Interface Flags
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1182
Cause
Trouble sending an ICMP echo request packet
for the UI ping command. Maybe there was no
route to that network.
Out of memory at system initialization time.
The /dev/tap file is missing, or, if not using the
reference kernel binary, the kernel is missing
"Universal TUN/TAP device driver support"
(CONFIG_TUN).
Trouble reading the /dev/tap device, check the
error message XX for details.
This pertains to the "event log" persistent file in
flash. Either it did not exist, or had a bad
checksum.
Event log file has been cleared; happens at boot
time.
Event log file had a non-blank entry after a blank
entry; therefore, something was messed up.
Trouble adding VRRP IP or MAC address(es) to
a network interface.