NETGEAR M6100 Series Reference Manual page 855

Parameter Description
neighbor-address [Optional] The IP address of a neighbor. Used to limit the output to show a single neighbor.
The command output displays the following information.
Parameter Description
Description Text string assigned using the command
text string only appears if a description is configured.
Remote Address The neighbor's IP address
Remote AS The neighbor's autonomous system number
Peer ID The neighbor's BGP router ID
Peer Admin Status START or STOP
Peer State The adjacency state of this neighbor
Local Interface The IPv4 address used as the source IP address in packets sent to this neighbor.
Address
Local Port TCP port number on the local end of the connection
Remote Port TCP port number on the remote end of the connection
Connection Retry How long BGP waits between connection retries
Interval
Neighbor Optional capabilities reported by the neighbor, recognized and accepted by this router. Codes listed
Capabilities in the show output are as follows:
• MP. Multiprotocol
• RF. Route Refresh
This version of NETGEAR Managed Switch does not support any multiprotocol AFI/SAFI pairs other
than IPv4 unicast. The presence of this capability does not imply otherwise.
IPv4 Unicast Indicates whether IPv4 unicast routes can be exchanged with this peer. Both indicates that IPv4 is
Support active locally and the neighbor indicated support for IPv4 unicast in its OPEN message. Sent
indicates that IPv4 unicast is active locally, but the neighbor did not include this AFI/SAFI pair in its
OPEN message.
IPv4 unicast is always enabled locally and cannot be disabled.
IPv6 Unicast Indicates whether IPv6 unicast routes can be exchanged with this peer. Both and Sent have the
Support same meaning as for IPv4. None indicates that neither the local router nor the peer has IPv6
enabled for this adjacency. Received indicates that the peer advertised the IPv6 unicast capability,
but it is not enabled locally. IPv6 unicast is enabled locally using the neighbor activate command in
address-family IPv6 configuration mode.
Update Source The configured value for the source IP address of packets sent to this peer. This field is only
included in the output if the update source is configured.
Configured Hold The time, in seconds, that this router proposes to this neighbor as the hold time
Time
M6100 Series Switches
Border Gateway Protocol Commands
855
neighbor filter-list (BGP Router Config) on page 823. This