NETGEAR M6100 Series Reference Manual page 745

The information below displays only if OSPF is enabled.
Term
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
Local Link LSAs
Local Link LSA Checksum
Prefix-suppression
Command example:
The following output displays when the OSPF Admin Mode is disabled:
(NETGEAR Routing) >show ip ospf interface 1/0/1
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Secondary IP Address(es).......................
OSPF Admin Mode................................ Disable
OSPF Area ID................................... 0.0.0.0
OSPF Network Type.............................. Broadcast
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Transmit Delay................................. 1
Authentication Type............................ None
Metric Cost.................................... 1
Passive Status................................. Non-passive interface
OSPF Mtu-ignore................................ Disable
Flood Blocking................................. Disable
OSPF is not enabled on this interface.
M6100 Series Switches
Definition
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value broadcast. The
OSPF Interface Type will be 'broadcast'.
The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router.
The router ID representing the designated router.
The router ID representing the backup designated router.
The number of link events.
The number of Link Local Opaque LSAs in the link-state database.
The sum of LS Checksums of Link Local Opaque LSAs in the link-state database.
Displays whether prefix-suppression is enabled, disabled, or unconfigured on the given
interface.
Routing Commands
745
(computed)