NETGEAR M6100 Series Reference Manual page 605

Below is additional information regarding the FCF that is displayed when the optional FCF
MAC address argument is provided.
Parameter Description
Sessions Total number of virtual sessions accepted by FCF in the associated VLAN.
D-bit This reflects the value of the D-bit provided by the most recently received Discovery Advertisement
from the FCF. When D-bit value is zero then FIP snooping bridge verifies the periodic VN_Port FIP
Keep Alive frames associated with FCF and Discovery Advertisements sent by FCF. When D-bit is
set to 1, switch discards snooped VN_Port FIP Keep Alive frames associated with FCF and does not
timeout the FCoE sessions established with the FCF based on FKA_VN_PERIOD*5 interval.
Available for Login This reflects the value of the A bit provided by the most recently received Discovery Advertisement
from the FCF. This provides the information that the transmitting FCF is available for FIP
FLOGI/FDISC from ENodes. This is informational and shall have no effect on existing logins.
Priority The Priority returned from the FCF in the Solicited Discovery Advertisement. This indicates the
Priority that has been manually assigned to the FCF.
FKA-ADV FIP keepalive interval (FKA_ADV_PERIOD) in seconds configured on the FCF multiplied by five.
For example, if the FKA_ADV period configured on the FCF is 80 seconds, the value of this field is
400.
FCF Expiry Time This is timer value to monitor the status of the FCF. FCF entry and all its associated virtual sessions
will be removed when the value reaches 0. This value is reset to Configured FKA-ADV every time a
Discovery Advertisement is received from the FCF-MAC.
Time Elapsed Time since FCF is Discovered.
Command example:
The following output displays when you provide no optional argument:
(config)# show fip-snooping fcf
-------------------------------------------------------------------------------
Interface VLAN ENodes FPMA/ FC-MAP
-------------------------------------------------------------------------------
1/0/11 1 2
3/0/10 1 1
3/0/15 100 1
Command example:
The following output displays when you provide the optional argument:
(NETGEAR Switch)# show
Interface
VLAN
ENodes
FPMA/SPMA
FCF-MAC
M6100 Series Switches
FCF-MAC
SPMA
FPMA 0e:fc:00 00:0d:ec:b2:2c:80 20:65:00:0d: 20:65:00:0d:
FPMA 0e:fc:00 00:0d:ec:b2:2c:81 00000000
FPMA 0e:fc:10 00:0c:ab:2c:eb:12 00000000
fip-snooping fcf
3/0/10
1
1
FPMA
00:0d:ec:b2:2c:81
Data Center Commands
605
Name-ID
ec:b1:9e:81
00:0d:ec:b2:2c:81
Fabric-Name
ec:97:52:c1
00000000
00000000