NETGEAR M6100 Series Reference Manual page 1045

Term
Starting Source L4 port
Ending Source L4 port
Starting Destination L4 port
Ending Destination L4 port
ICMP Code
Fragments
Committed Rate
Committed Burst Size
Source IP Address
Source IP Mask
Source L4 Port Keyword
Destination IP Address
Destination IP Mask
Destination L4 Port Keyword
IP DSCP
IP Precedence
IP TOS
Log
Assign Queue
Mirror Interface
Redirect Interface
Time Range Name
Rule Status
Command example:
(NETGEAR Routing) #show ip access-lists ip1
ACL Name: ip1
Inbound Interface(s): 1/0/30
Rule Number: 1
Action......................................... permit
M6100 Series Switches
Definition
The starting source layer 4 port.
The ending source layer 4 port.
The starting destination layer 4 port.
The ending destination layer 4 port.
Note: This is shown only if the protocol is ICMP.
The ICMP message code for this rule.
If the ACL rule matches on fragmented IP packets.
The committed rate defined by the rate-limit attribute.
The committed burst size defined by the rate-limit attribute.
The source IP address for this rule.
The source IP Mask for this rule.
The source port for this rule.
The destination IP address for this rule.
The destination IP Mask for this rule.
The destination port for this rule.
The value specified for IP DSCP.
The value specified IP Precedence.
The value specified for IP TOS.
Displays when you enable logging for the rule.
The queue identifier to which packets matching this rule are assigned.
The unit/slot/port to which packets matching this rule are copied.
The unit/slot/port to which packets matching this rule are forwarded.
Displays the name of the time-range if the IP ACL rule has referenced a time range.
Status (Active/Inactive) of the IP ACL rule.
Quality of Service Commands
1045