Lacp Actor Admin State; Lacp Actor Admin State Passive - NETGEAR M6100 Series Reference Manual

Note: This command is applicable only to physical interfaces.
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Format
no lacp actor admin state longtimeout
Mode Interface Config
Note: This command is applicable only to physical interfaces.

lacp actor admin state passive

Use this command to set the LACP actor admin state to passive.
Format
lacp actor admin state passive
Mode Interface Config
Note: This command is applicable only to physical interfaces.
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format
no lacp actor admin state passive
Mode Interface Config

lacp actor admin state

Use this command to configure the administrative value of actor state as transmitted by the
Actor in LACPDUs. This command can be used to configure a single interfaces or a range of
interfaces.
Default 0x07
Format
lacp actor admin state {individual | longtimeout | passive}
Mode Interface Config
M6100 Series Switches
Switching Commands
447