Dot1X Max-Users; Dot1X Port-Control - NETGEAR M6100 Series Reference Manual

no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
Format
no dot1x max-req
Mode Interface Config

dot1x max-users

Use this command to set the maximum number of clients supported on an interface or range
of interfaces when MAC-based dot1x authentication is enabled on the port. The maximum
users supported per port is dependent on the product. The count parameter must be in the
range 1–48.
Default 48
Format
dot1x max-users count
Mode Interface Config
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
Format
no dot1x max-users
Mode Interface Config

dot1x port-control

This command sets the authentication mode to use on the specified interface or range of
interfaces. Use the force-unauthorized parameter to specify that the authenticator PAE
unconditionally sets the controlled port to unauthorized. Use the force-authorized
parameter to specify that the authenticator PAE unconditionally sets the controlled port to
authorized. Use the auto parameter to specify that the authenticator PAE sets the controlled
port mode to reflect the outcome of the authentication exchanges between the supplicant,
authenticator and the authentication server. If the mac-based parameter is specified, then
MAC-based dot1x authentication is enabled on the port.
Default
auto
Format
dot1x port-control {force-unauthorized | force-authorized | auto | mac-based}
Mode Interface Config
M6100 Series Switches
Switching Commands
399