Ip Ospf Area; Ospf Interface Commands - NETGEAR M6100 Series Reference Manual

Default disabled
Format
trapflags {all | errors {all | authentication-failure | bad-packet |
config-error | virt-authentication-failure | virt-bad-packet |
virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all |
lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | state-change {all | if-state-change | neighbor-state-change |
virtif-state-change | virtneighbor-state-change}}
Mode Router OSPF Config
no trapflags
Use this command to revert to the default reference bandwidth.
• To disable the individual flag, enter no trapflags and the trapflag group name
followed by the individual flag.
• To disable all the flags in that group, enter no trapflags and the trapflag group
name followed by all.
• To disable all flags, enter the command as no trapflags all.
Format
no trapflags {all | errors {all | authentication-failure | bad-packet |
config-error | virt-authentication-failure | virt-bad-packet |
virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all |
lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | state-change {all | if-state-change | neighbor-state-change |
virtif-state-change | virtneighbor-state-change}}
Mode Router OSPF Config

OSPF Interface Commands

ip ospf area

Use this command to enable OSPFv2 and set the area ID of an interface or range of
interfaces. The area-id is an IP address formatted as a 4-digit dotted-decimal number or a
decimal value in the range of 0–4294967295. This command supersedes the effects of the
network area command. It can also be used to configure the advertiseability of the
secondary addresses on this interface into the OSPFv2 domain.
Default disabled
Format
ip ospf area area-id [secondaries none]
Mode Interface Config
M6100 Series Switches
Routing Commands
722