NETGEAR M6100 Series Reference Manual page 474

Use the filter parameter to filter a specified access group either by IP address or MAC
address.
Format
monitor session session-id {source {interface unit/slot/port | cpu |
vlan-id | remote vlan vlan-id }[{rx | tx}] | destination {interface
unit/slot/port |remote vlan vlan-id reflector-port unit/slot/port}| mode |
filter {ip access-group [acl-id | aclname] |mac access-group acl-name}}
Mode Global Config
Command example:
To configure the RSPAN VLAN source:
monitor session session-id source {interface unit/slot/port | vlan vlan-id | remote vlan
vlan-id }[rx | tx]
Command example:
To the configure RSPAN VLAN destination:
monitor session session-id destination {interface unit/slot/port | remote vlan vlan-id
reflector-port unit/slot/port}
Command example:
To attach an ACL:
monitor session session-id filter {ip access-group [acl-id | aclname] | mac access-group
acl-name}
no monitor session
Use this command without optional parameters to remove the monitor session (port
monitoring) designation from the source probe port, the destination monitored port and all
VLANs. Once the port is removed from the VLAN, you must manually add the port to any
desired VLANs. Use the source interface unit/slot/port parameter or
destination interface to remove the specified interface from the port monitoring
session. Use the mode parameter to disable the administrative mode of the session.
Note: Since the current version of NETGEAR Managed Switch software
only supports one session, if you do not supply optional parameters,
the behavior of this command is similar to the behavior of the no
monitor command.
Format
no monitor session session-id [{source interface unit/slot/port | destination
interface | mode |filter {ip access-group |mac access-group}}]
Mode Global Config
M6100 Series Switches
Switching Commands
474
|
vlan