Show Ip Access-Lists - NETGEAR M6100 Series Reference Manual

no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode Global Config

show ip access-lists

Use this command to view summary information about all IP ACLs configured on the switch.
To view more detailed information about a specific access list, specify the ACL number or
name that is used to identify the IP ACL.
Format
show ip access-lists [accesslistnumber | name]
Mode Privileged EXEC
Term
ACL ID/Name
Rules
Direction
Interface(s)
VLAN(s)
If you specify an IP ACL number or name, the following information displays:
Note: Only the access list fields that you configure are displayed. Thus, the
command output varies based on the match criteria configured within
the rules of an ACL.
Term
Rule Number
Action
Match All
Protocol
ICMP Type
M6100 Series Switches
Definition
Identifies the configured ACL number or name.
Identifies the number of rules configured for the ACL.
Shows whether the ACL is applied to traffic coming into the interface (ingress) or
leaving the interface (egress).
Identifies the interface(s) to which the ACL is applied (ACL interface bindings).
Identifies the VLANs to which the ACL is applied (ACL VLAN bindings).
Definition
The number identifier for each rule that is defined for the IP ACL.
The action associated with each rule. The possible values are Permit or Deny.
Indicates whether this access list applies to every packet. Possible values are True or
False.
The protocol to filter for this rule.
Note: This is shown only if the protocol is ICMP.
The ICMP message type for this rule.
Quality of Service Commands
1044