lacp partner system-id
Use this command to configure the 6-octet MAC Address value representing the
administrative value of the Aggregation Port's protocol Partner's System ID. This command
can be used to configure a single interface or a range of interfaces. The valid range of
system-id is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
Default
00:00:00:00:00:00
Format
lacp partner system-id system-id
Mode
Interface Config
Note:
This command is applicable only to physical interfaces.
no lacp partner system-id
Use this command to configure the default value representing the administrative value of the
Aggregation Port's protocol Partner's System ID.
Format
no lacp partner system-id
Mode
Interface Config
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner's System ID. This command can be used to configure a single interface or a range of
interfaces. The valid range for priority is 0 to 65535.
Default
0x0
Format
lacp partner system priority priority
Mode
Interface Config
Note:
This command is applicable only to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner's System ID.
Format
no lacp partner system priority
Mode
Interface Config
M6100 Series Switches
Switching Commands
452