Redistribute (Ipv6 Address Family Config) - NETGEAR M6100 Series Reference Manual

Parameter Description
match (Optional) If you configure BGP to redistribute OSPF routes, BGP by default only redistributes
internal routes (OSPF intra-area and inter-area routes). Use the match option to configure BGP to
also redistribute specific types of external routes, or to disable redistribution of internal OSPF
routes.
route-map map-tag (Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix
list. A route map can be used to set attributes on redistributed routes.
no redistribute (BGP Router Config)
This command removes the configuration for the redistribution for BGP protocol from the
specified source protocol/routers. The command no redistribute opsf match
external 1 withdraws only OSPF external type 1 routes, OSPF internal routes are still
redistributed.
Format
no redistribute {ospf | rip | connected | static} [metric metric-value]
[match {internal | external 1 | external 2 | nssa-external 1 |
nssa-external 2}] [route-map map-tag]
Mode BGP Router Config

redistribute (IPv6 Address Family Config)

This command configures BGP to non-BGP routes from the IPv6 routing table. NETGEAR
Managed Switch software does not support RIP for IPv6.
The distribute-list out command can also be used to filter redistributed routes by prefix. Either
a redistribute route map or a distribute list may be configured, but not both.
A default route cannot be redistributed unless the
Config) command is given.
If a route map is configured, match as-path and match community terms are ignored. If no
route map is configured with the name given, no prefixes are redistributed.
Default BGP redistributes no routes by default. When BGP redistributes OSPF routes, it redistributes only
internal routes unless the match option specifies external routes.
Format
redistribute {ospf | connected | static} [metric metric-value]
[match {internal | external 1 | external 2 | nssa-external 1 |
nssa-external 2}] [route-map map-tag]
Mode IPv6 Address Family Config
M6100 Series Switches
default-information originate (BGP Router
Border Gateway Protocol Commands
840