Ip Prefix-List - NETGEAR M6100 Series Reference Manual

Command example:
(NETGEAR Routing) (Config)#interface 1/0/1
(NETGEAR Routing) (Interface 1/0/1)#
(NETGEAR switch) (Interface 1/0/1)# #ip policy route-map equal-access
no ip policy route-map
Use this command to disable policy-based routing on an interface.
Format
no ip policy route-map-name
Mode Interface Config

ip prefix-list

To create a prefix list or add a prefix list entry, use the ip prefix-list command in Global
Configuration mode. Prefix lists allow matching of route prefixes with those specified in the
prefix list. Each prefix list includes of a sequence of prefix list entries ordered by their
sequence numbers. A router sequentially examines each prefix list entry to determine if the
route's prefix matches that of the entry. An empty or nonexistent prefix list permits all
prefixes. An implicit deny is assume if a given prefix does not match any entries of a prefix
list. Once a match or deny occurs the router does not go through the rest of the list. A prefix
list may be used within a route map to match a route's prefix using the command
address on page 659.
Up to 128 prefix lists may be configured. The maximum number of statements allowed in
prefix list is 64.
Default No prefix lists are configured by default. When neither the ge nor the le option is configured, the
destination prefix must match the network/length exactly. If the ge option is configured without the le
option, any prefix with a network mask greater than or equal to the ge value is considered a match.
Similarly, if the le option is configured without the ge option, a prefix with a network mask less than or
equal to the le value is considered a match.
Format
ip prefix-list list-name [seq number] {{permit | deny} network/length [ge
length] [le length] | renumber renumber-interval first-statement-number}
Mode Global Configuration
Parameter Description
list-name The text name of the prefix list. Up to 32 characters.
seq number (Optional) The sequence number for this prefix list statement. Prefix list statements are ordered from
lowest sequence number to highest and applied in that order. If you do not specify a sequence
number, the system will automatically select a sequence number five larger than the last sequence
number in the list. Two statements may not be configured with the same sequence number. The
value ranges from 1 to 4,294,967,294.
permit Permit routes whose destination prefix matches the statement.
deny Deny routes whose destination prefix matches the statement.
M6100 Series Switches
Routing Commands
653
match ip