Passive-Interface (Ospfv); Redistribute (Ospfv) - NETGEAR M6100 Series Reference Manual

passive-interface (OSPFv3)
Use this command to set the interface or tunnel as passive.
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id
parameter is a number in the range of 1–4093. You can also use the tunnel keyword and
tunnel-id argument.
Using these arguments overrides the global passive mode that is effective on the interface or
tunnel.
Default disabled
Format
passive-interface {unit/slot/port | vlan vland-id | tunnel tunnel-id}
Mode Router OSPFv3 Config
no passive-interface
Use this command to set the interface, VLAN, or tunnel as nonpassive. It overrides the global
passive mode that is currently effective on the interface or tunnel.
Format
no passive-interface {unit/slot/port | vlan vlan-id | tunnel tunnel-id}
Mode Router OSPFv3 Config
redistribute (OSPFv3)
This command configures the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers. The metric argument can be a number in the range
0–16777214. The metric type can be 1 or 2. The tag argument can be a number in the range
0–4294967295.
Default metric—unspecified
type—2
tag—0
Format
redistribute {static | connected} [metric metric] [metric-type {1 | 2}]
[tag taq]
Mode Router OSPFv3 Config
M6100 Series Switches
IPv6 Commands
940