Traffic-Class-Group Min-Bandwidth - NETGEAR M6100 Series Reference Manual

Note: A value of 0 (the default) implies an unrestricted upper transmission
limit, which is similar to 100%, although there may be subtle
operational differences depending on how the device handles a no
limit case versus limit to 100%.
no traffic-class-group max-bandwidth
Use the no traffic-class-group max-bandwidth command in Global Config or
Interface Config mode to restore the default for each queue's maximum bandwidth value.
Format
no traffic-class-group max-bandwidth
Mode Global Config
Interface Config

traffic-class-group min-bandwidth

Use the traffic-class-group min-bandwidth command in Global Config or Interface
Config mode to specify the minimum transmission bandwidth (bw) guarantee for each
interface TCG. The total number of TCG supported per interface is platform specific.
Default Min-bandwidth is zero for all TCG.
Format
traffic-class-group min-bandwidth bw-0 bw-1 ... bw-n
Mode Global Config
Interface Config
The command specified in Interface Config mode only affects a single interface, whereas the
Global Config mode setting is applied to all interfaces. The Interface Config mode command
is only available on platforms that support independent per-port class-of-service queue
configuration.
Each bw-x value is a percentage that ranges from 0 to 100 in increments of 1. All n bandwidth
values must be specified with this command, and their combined sum must not exceed
100%. The number n is platform dependent and corresponds to the number of supported
Traffic Class Groups. The default minimum bandwidth value for each TCG is 0, meaning no
bandwidth is guaranteed (best effort).
If the value of any bw-x minimum bandwidth parameter is specified as greater than the
current maximum bandwidth value for the corresponding TCG, then its corresponding
maximum bandwidth automatically increases the maximum to the same value.
M6100 Series Switches
Data Center Commands
594