Virtual Router Redundancy Protocol (Vrrp) Commands; Ip Vrrp; Section 14.5 "Virtual Router Redundancy Protocol (Vrrp) Commands - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
MAC Address
used by Routing
VLANs
VLAN ID
Logical Interface
IP Address
Subnet Mask
14.5 Virtual Router Redundancy Protocol (VRRP)
Commands
This section describes the commands you use to view and configure VRRP and to view
VRRP status information. VRRP helps provide failover and load balancing when you
configure two devices as a VRRP pair.

14.5.1 ip vrrp

This command enables the VRRP protocol on an interface and designates the configured
virtual router IP address as a secondary IP address on an interface. The parameter
is the virtual router ID which has an integer value range from 1 to 255.
Default
Format
Mode
14.5.1.1 no ip vrrp
This command disables the VRRP protocol on an interface. This command also removes a
virtual router IP address as a secondary IP address on an interface. The parameter
is the virtual router ID which has an integer value ranges from 1 to 255.
Format
Mode
Routing Commands
Is the MAC Address associated with the internalbridge-router
interface (IBRI). The same MAC Address is used by all
VLAN routing interfaces. It will be displayed above the per-
VLAN information.
Is the identifier of the VLAN.
Shows the logical slot/port associated with the VLAN routing
interface.
Displays the IP Address associated with this VLAN.
Indicates the subnet mask that is associated with this VLAN.
none
ip vrrp <vrID> <ipaddress> [secondary]
Interface Config
no ip vrrp <vrID> <ipaddress> [secondary]
Interface Config
v1.0, December 2005
<vrID>
<vrID>
14-23