Virtual Router Redundancy Protocol Commands; Show Ip Vlan; Ip Vrrp (Global Config) - NETGEAR ProSafe M7100-24X User Manual

no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4093.
Format
no vlan routing <vlanid>
Mode
VLAN Config

show ip vlan

This command displays the VLAN routing information for all VLANs with routing enabled.
Format
show ip vlan
Modes
• Privileged EXEC
• User EXEC
Term Definition
MAC Address
The MAC Address associated with the internal bridge-router interface (IBRI). The same
used by
MAC Address is used by all VLAN routing interfaces. It will be displayed above the
Routing VLANs
per-VLAN information.
VLAN ID
The identifier of the VLAN.
Logical
The logical unit/slot/port associated with the VLAN routing interface.
Interface
IP Address
The IP address associated with this VLAN.
Subnet Mask
The subnet mask that is associated with this VLAN.

Virtual Router Redundancy Protocol Commands

This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.

ip vrrp (Global Config)

Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default
none
Format
ip vrrp
Mode
Global Config
ProSafe Managed Switch
Routing Commands
244