NETGEAR M6100 Series Reference Manual page 860

Hide thumbs Also See for M6100 Series:

Table of Contents

The command output displays the following information.

BGP table version

Each time phase 2 of the BGP decision process runs to select new BGP routes, this number is

Status codes

p – The route has been updated in Adj-RIB-Out since the last UPDATE message was sent.

Transmission of an UPDATE message is pending.

Destination prefix

The BGP NEXT HOP as advertised to the peer.

The local preference. Local preference is never advertised to external peers.

The value of the Multi Exit Discriminator, if the MED is advertised to the peer.

The AS path. The AS path does not include the local AS number, which is added to the beginning of

the AS path when a route is advertised to an external peer.

The value of the ORIGIN attribute follows immediately after the AS Path.

Command example:

(NETGEAR Switch) #show ip bgp neighbors 172.20.101.100 advertised-routes

BGP table version is 5, local router ID is 20.1.1.1

Status codes: p advertisement pending

Origin codes: i - IGP, e - EGP, ? - incomplete

Originating default network 0.0.0.0

172.20.1.0/24

This output differs slightly from the output in show ip bgp command.

Suppressed routes and nonbest routes are not advertised, so these

status codes are not relevant here. Advertised routes always have a

single next hop, the BGP NEXT HOP advertised to the peer. Local

preference is never sent to external peers.

The output indicates whether BGP is configured to originate a default route to this peer

(neighbor default-originate).

M6100 Series Switches

172.20.101.1

Border Gateway Protocol Commands

Chapters

Table of Contents