NETGEAR M6100 Series Reference Manual page 847

timers
Use this command in Peer Template Configuration mode to configure the keepalive and hold
timers in a peer template.
Default The keepalive and hold timers default to the globally configured values set with the
command.
Format
timers keepalive holdtime
Mode Peer Template Config
Parameter Description
keepalive The time, in seconds, between BGP KEEPALIVE packets sent to a neighbor. The range is 0 to
65,535 seconds. Jitter is applied to the keepalive interval.
holdtime The time, in seconds, that BGP continues to consider a neighbor to be alive without receiving a BGP
KEEPALIVE or UPDATE packet from the neighbor. If no KEEPALIVE is received from a neighbor for
longer than the hold time, BGP drops the adjacency. If the hold time is set to 0, then BGP does not
enforce a hold time and BGP does not send periodic KEEPALIVE messages. The range is 0 to
65,535 seconds.
no timers
This command reverts the keep alive and hold time for a peer template to their defaults. After
executing this command, the BGP peer must be reset before the changes will take effect.
Format
no timers
Mode Peer Template Config
update-source
Use this command in Peer Template Configuration mode to configure a peer template to use
a specific interface as the source for the TCP connection with a neighbor. You can enter an
interface in the unit/slot/port format or a loopback interface in the loopback number
format.
Default When no update source is configured, TCP connections use the primary IPv4 address on the outgoing
interface to the neighbor.
Format
update-source [unit/slot/port | loopback number]
Mode Peer Template Config
M6100 Series Switches
Border Gateway Protocol Commands
847
address-family