Show Ipv6 Ospf Lsa-Group - NETGEAR M6100 Series Reference Manual

Term Definition
Invalid OSPF Packet The number of OSPF packets discarded because the packet type field in the OSPF header is not
Type a known type.
Hellos Ignored The number of received Hello packets that were ignored by this router from the new neighbors
after the limit has been reached for the number of neighbors on an interface or on the system as
a whole.
The table in trapflags (OSPF)
sent and received on the interface.

show ipv6 ospf lsa-group

This command displays the number of self-originated LSAs within each LSA group.
Format
show ipv6 ospf lsa-group
Modes Privileged EXEC
User EXEC
Term Definition
Total The number of LSAs the router is currently originating.
self-originated
LSAs
Average LSAs per The number of self-originated LSAs divided by the number of LSA groups. The number of LSA
group groups is the refresh interval (1800 seconds) divided by the pacing interval (configured with the
timers pacing lsa-group command) plus two.
Pacing group limit The maximum number of self-originated LSAs in one LSA group. If the number of LSAs in a group
exceeds this limit, OSPF redistributes LSAs throughout the refresh interval to achieve better
balance.
Groups For each LSA pacing group, the output shows the range of LSA ages in the group and the number of
LSAs in the group.
Command example:
(R1) #show ipv6 ospf lsa-group
Total self-originated LSAs:
Average LSAs per group:
Pacing group limit:
Number of self-originated LSAs within each LSA group...
Group Start Age Group End Age
0
60
120
M6100 Series Switches
on page 721 lists the number of OSPF packets of each type
3019
100
400
Count
59 96
119 88
179 102
IPv6 Commands
964