interface loopback
Use this command to enter the Interface Config mode for a loopback interface. The range of
the loopback ID is 0 to 7.
Format
interface loopback loopback-id
Mode
Global Config
no interface loopback
This command removes the loopback interface and associated configuration parameters for
the specified loopback interface.
Format
no interface loopback loopback-id
Mode
Global Config
show interface loopback
This command displays information about configured loopback interfaces.
Format
show interface loopback [loopback-id]
Mode
Privileged EXEC
If you do not specify a loopback ID, the following information appears for each loopback
interface on the system.
Term
Definition
Loopback ID
The loopback ID associated with the rest of the information in the row.
Interface
The interface name.
IP Address
The IPv4 address of the interface.
If you specify a loopback ID, the following information appears.
Term
Definition
Interface Link
Shows whether the link is up or down.
Status
IP Address
The IPv4 address of the interface.
MTU size
The maximum transmission size for packets on this interface, in bytes.
M6100 Series Switches
IPv6 Commands
893