Show Ipv6 Mroute Source; Show Ipv6 Mroute Static - NETGEAR M6100 Series Reference Manual

show ipv6 mroute source

This command displays the multicast configuration settings specific to IPv6 such as flags,
timer settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration
times of all the entries in the multicast mroute table containing the given source IP address
(source-address) or source IP address and group IP address (groupipaddr) pair.
Format
show ipv6 mroute source source-address {groupipaddr | summary}
Modes Privileged EXEC
User EXEC
If you use the groupipaddr parameter, the command displays the following column
headings in the output table.
Term Definition
Source IP Addr The IP address of the multicast data source.
Group IP Addr The IP address of the destination of the multicast packet.
Expiry Time The time of expiry of this entry in seconds.
Up Time The time elapsed since the entry was created in seconds.
RPF Neighbor The IP address of the RPF neighbor.
Flags The flags associated with this entry.
If you use the summary parameter, the command displays the following column headings in
the output table.
Term
Source IP Addr
Group IP Addr
Protocol
Incoming Interface
Outgoing Interface List

show ipv6 mroute static

Use the show ipv6 mroute static command in Privileged EXEC or User EXEC mode
to display all the configured IPv6 multicast static routes.
Format
show ipv6 mroute static [source-address]
Modes Privileged EXEC
User EXEC
M6100 Series Switches
Definition
The IP address of the multicast data source.
The IP address of the destination of the multicast packet.
The multicast routing protocol by which this entry was created.
The interface on which the packet for this source arrives.
The list of outgoing interfaces on which this packet is forwarded.
IPv6 Multicast Commands
1113