NETGEAR M6100 Series Reference Manual page 870

Parameter Description
UPDATE Send The number of UPDATE messages that failed to be delivered to all members of the group
Failures
Current Members The IPv4 address of all current members of the group
The update send history table show statistics on as many as the ten most recent executions
of the update send process for the update group. Items in the history table are as follows.
Parameter Description
Version The update version
Delta T The amount of time elapsed since the update send process executed. hours::minutes::seconds.
Duration How long the update send process took, in milliseconds.
UPD Built The number of UPDATE messages built
UPD Sent The number of UPDATE messages successfully transmitted to group members. Normally a copy of
each UPDATE message built is sent to each group member.
Paths Sent The number of paths advertised.
Pfxs Adv The number of prefixes advertised
Pfxs Wd The number of prefixes withdrawn
Command example:
The following example displays information for all update groups:
(R1) # show ip bgp update-group
Update Group ID............................ 0
Peer Type.................................. External
Minimum Advertisement Interval............. 30 seconds
Send Community............................. Yes
Remove Private ASNs........................ No
Route Reflector Client..................... No
Neighbor AS Path Access List Out........... 1
Neighbor Prefix List Out................... pfxList1
Members Added.............................. 48
Members Removed............................ 0
Update Version............................. 19
Number of UPDATEs Sent..................... 512
Time Since Last Update..................... 5 hrs 3 min 2 sec
Current Prefixes........................... 5500
Current Paths.............................. 22
Prefixes Advertised........................ 191250
Prefixes Withdrawn......................... 186000
UPDATE Send Failures....................... 0
M6100 Series Switches
Border Gateway Protocol Commands
870