show vpc peer-keepalive
This command displays the peer VPC switch IP address used by the dual control plane
detection protocol. The port used for the DCPDP is shown. This command also displays if
peer detection is enabled. If enabled, the detection status is displayed.
Format
show vpc peer-keepalive
Mode
User EXEC
Command example:
(NETGEAR Switch) # show vpc peer-keepalive
Peer IP address ......................................... 10.130.14.55
Source IP address...................................... 10.130.14.54
UDP port ............................................................ 60000
Peer detection ........................................ ENABLED
Peer is detected....................................... TRUE
show vpc role
This command displays information about the keepalive status and parameters. The role of
the VPC switch as well as the system MAC address and priority are displayed.
Format
show vpc role
Mode
User EXEC
Command example:
(NETGEAR Switch) # show vpc role
Self
----
Keepalive config mode.......................... Enabled
Keepalive operational mode..................... Enabled
Priority....................................... 100
System MAC..................................... 00:10:18:82:18:63
Timeout........................................ 5
VPC State...................................... Primary
VPC Role....................................... Primary
Peer
----
Priority....................................... 100
VPC Role....................................... Secondary
System MAC..................................... 00:10:18:82:1b:ab
M6100 Series Switches
Switching Commands
469