Ip Name Source-Interface; Ip Host - NETGEAR M6100 Series Reference Manual

ip name source-interface

Use this command to specify the physical or logical interface to use as the DNS client (IP
name) source interface (source IP address) for the DNS client management application. If
configured, the address of source Interface is used for all DNS communications between the
DNS server and the DNS client. The selected source-interface IP address is used for filling
the IP header of management protocol packets. This allows security devices (firewalls) to
identify the source packets coming from the specific switch. If a source-interface is not
specified, the primary IP address of the originating (outbound) interface is used as the source
address. If the configured interface is down, the DNS client falls back to its default behavior.
Format
ip name source-interface {unit/slot/port | loopback loopback-id | tunnel
tunnel-id | vlan vlan-id}
Mode Global Config
no ip name source-interface
Use this command to reset the DNS source interface to the default settings.
Format
no ip name source-interface
Mode Global Config

ip host

Use this command to define static host name-to-address mapping in the host cache. The
parameter name is host name and ipaddress is the IP address of the host. The host name
can include 1–255 alphanumeric characters, periods, hyphens, underscores, and
non-consecutive spaces. Hostnames that include one or more space must be enclosed in
quotation marks, for example "lab-pc 45".
Default none
Format
ip host name ipaddress
Mode Global Config
no ip host
Use this command to remove the name-to-address mapping.
Format
no ip host name
Mode Global Config
M6100 Series Switches
Utility Commands
232