NETGEAR M6100 Series Reference Manual page 1175

Table 67. PIM-SM Log Messages
Component Message
PIMSM Non-Zero SPT/Data Threshold Rate – xxx is
currently Not Supported on this platform.
PIMSM PIMSM Protocol Heap Memory Init Failed;
Family – xxx.
PIMSM PIMSM Protocol Heap Memory De-Init Failed;
Family –xxx.
PIMSM PIMSM Protocol Initialization Failed; Family –xxx. PIMSM protocol initialization sequence Failed.
PIMSM PIMSM Protocol De-Initialization Failed; Family –
xxx.
PIMSM PIMSM SSM Range Table is Full.
PIMSM PIM All Routers Address – xxx Delete from the
DTL Mcast List Failed for intf – xxx.
PIMSM PIM All Routers Address - xxx Add to the DTL
Mcast List Failed for intf – xxx.
PIMSM Mcast Forwarding Mode Disable Failed for intf –
xxx.
PIMSM Mcast Forwarding Mode Enable Failed for intf –
xxx.
PIMSM PIMSMv6 Socket Memb'ship Enable Failed for
rtrIfNum - xxx.
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1175
Cause
This message appears when the user tries to
configure the PIMSM SPT threshold value.
PIMSM Heap memory initialization Failed for the
specified address family. This message appears
when trying to enable PIMSM Protocol.
PIMSM Heap memory de-initialization Failed for
the specified address family. This message
appears when trying to disable PIMSM Protocol.
As a result of this, the subsequent attempts to
enable/disable PIMSM will also fail.
This could be due to the non-availability of some
resources. This message appears when trying to
enable PIMSM Protocol.
PIMSM protocol de-initialization sequence
Failed. This message appears when trying to
disable PIMSM Protocol.
PIMSM SSM Range Table is Full. This message
appears when the protocol cannot accommodate
new SSM registrations.
PIM All Routers Address deletion from the local
multicast list Failed. As a result of this, PIM
Multicast packets are still received at the
application though PIM is disabled.
PIM All Routers Address addition to the local
multicast list Failed. As a result of this, PIM
Multicast packets with this address will not be
received at the application.
Multicast Forwarding Mode Disable Failed. As a
result of this, Multicast packets are still received
at the application though no protocol is enabled.
Multicast Forwarding Mode Enable Failed. As a
result of this, Multicast packets will not be
received at the application though a protocol is
enabled.
PIMSMv6 Socket Creation/options Set with
Kernel IP Stack Failed. As a result of this, the
PIM Control packets cannot be received on the
interface.