timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both
the delay time and hold time parameters is 0–65535 seconds.
Default
delay-time—5
hold-time—10
Format
timers spf delay-time hold-time
Mode
Router OSPF Config
trapflags (OSPF)
Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or
enable all the trap flags at a time. The different groups of trapflags, and each group's specific
trapflags to enable or disable, are listed in the following table.
Table 11. Trapflags groups
Group
Flags
errors
•
authentication-failure
•
bad-packet
•
config-error
•
virt-authentication-failure
•
virt-bad-packet
•
virt-config-error
lsa
•
lsa-maxage
•
lsa-originate
overflow
•
lsdb-overflow
•
lsdb-approaching-overflow
retransmit
•
packets
•
virt-packets
state-change
•
if-state-change
•
neighbor-state-change
•
virtif-state-change
•
virtneighbor-state-change
•
To enable the individual flag, enter trapflags and the trapflag group name followed by
the individual flag.
•
To enable all the flags in that group, enter trapflags and the trapflag group name
followed by all.
•
To enable all flags, enter the command as trapflags all.
M6100 Series Switches
Routing Commands
721