Dot1X Port-Control All; Dot1X Mac-Auth-Bypass - NETGEAR M6100 Series Reference Manual

no dot1x port-control
This command sets the 802.1X port control mode on the specified port to the default value.
Format
no dot1x port-control
Mode Interface Config

dot1x port-control all

This command sets the authentication mode to use on all ports. Select the
force-unauthorized parameter to specify that the authenticator PAE unconditionally sets
the controlled port to unauthorized. Select the force-authorized parameter to specify
that the authenticator PAE unconditionally sets the controlled port to authorized. Select the
auto parameter to specify that the authenticator PAE sets the controlled port mode to reflect
the outcome of the authentication exchanges between the supplicant, authenticator and the
authentication server. If the mac-based parameter is specified, then MAC-based dot1x
authentication is enabled on the port.
Default auto
Format
dot1x port-control all {force-unauthorized | force-authorized | auto |
mac-based}
Mode Global Config
no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
Format
no dot1x port-control all
Mode Global Config

dot1x mac-auth-bypass

If the 802.1X mode on the interface is mac-based, you can optionally use this command to
enable MAC Authentication Bypass (MAB) on an interface. MAB is a supplemental
authentication mechanism that allows 802.1X unaware clients – such as printers, fax
machines, and some IP phones—to authenticate to the network using the client MAC
address as an identifier.
Default disabled
Format
dot1x mac-auth-bypass
Mode Interface Config
M6100 Series Switches
Switching Commands
400