router-lsa summary-lsa command causes OSPF to send summary LSAs with metrics
computed using normal procedures defined in RFC 2328.
Format
no max-metric router-lsa [on-startup] [summary-lsa]
Mode
OSPFv2 Router Configuration
clear ip ospf stub-router
Use the clear ip ospf stub-router command in Privileged EXEC mode to force OSPF to exit
stub router mode when it has automatically entered stub router mode because of a resource
limitation. OSPF only exits stub router mode if it entered stub router mode because of a
resource limitation or it if is in stub router mode at startup. This command has no effect if
OSPF is configured to be in stub router mode permanently.
Format
clear ip ospf stub-router
Mode
Privileged EXEC
OSPF Show Commands
show ip ospf
This command displays information relevant to the OSPF router.
Format
show ip ospf
Mode
Privileged EXEC
Note:
Some of the information below displays only if you enable OSPF and
configure certain features.
Term
Definition
Router ID
A 32-bit integer in dotted decimal format identifying the router, about which information is displayed.
This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a
configured value.
RFC 1583
Indicates whether 1583 compatibility is enabled or disabled. This is a configured value.
Compatibility
External LSDB
The maximum number of nondefault AS-external-LSA (link state advertisement) entries that can be
Limit
stored in the link-state database.
Exit Overflow
The number of seconds that, after entering overflow state, a router will attempt to leave overflow
Interval
state.
M6100 Series Switches
Routing Commands
735