Captive Portal Local User Commands; User (Captive Portal Config Mode) - NETGEAR M6100 Series Reference Manual

Captive Portal Local User Commands

Use these commands to view and configure captive portal users in the local database.

user (Captive Portal Config Mode)

This command is used to create a local user. The user-id variable is the user ID, which can
be a number between 1 and 128. The username variable is the name of the user and can
have up to 32 alphanumeric characters. The password variable is 8-64 characters.
Two ways exist to create a user: with the user name command or with the user password
command. If the user is created with the user name command, you must assign the
password with the user password command. If the user is created with the user
password command, you can assign the name with the user name command at a later
time.
You can also modify the password after you created a user by using the user password
command with the user ID and a new password.
Format
user user-id name username
Mode Captive Portal Config
Format
user user-id password password
Mode Captive Portal Config
Command example:
The following example uses name to create the user.
(NETGEAR Switch)(Config-CP) #user 1 name test
Command example:
The following example uses password to create the user:
(NETGEAR Switch)(Config-CP) #user 1 password test1234
no user
This command deletes a user from the local user database. If the user has an existing
session, it is disconnected. The user-id variable is the user ID, which can be a number
between 1 and 128.
Format
no user user-id
Mode Captive Portal Config
Command example:
(NETGEAR Switch)(Config-CP) #no user 1
M6100 Series Switches
Captive Portal Commands
789