Show Ip Interface - NETGEAR M6100 Series Reference Manual

Default Time to Live........................... 64
Routing Mode................................... Disabled
Maximum Next Hops.............................. 4
Maximum Routes................................. 128
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled

show ip interface

This command displays all pertinent information about the IP interface. The argument
unit/slot/port corresponds to a physical routing interface or VLAN routing interface.
The keyword vlan is used to specify the VLAN ID of the routing VLAN directly instead of in a
unit/slot/port format.
The vlan-id is a number in the range 1–4093. The loopback number is in the range 0–7.
Format
show ip interface {unit/slot/port | vlan vland-id | loopback number}
Modes Privileged EXEC
User EXEC
Term Definition
Routing Interface Determine the operational status of IPv4 routing Interface. The possible values are Up or Down.
Status
Primary IP Address The primary IP address and subnet masks for the interface. This value appears only if you configure
it.
Method Shows whether the IP address was configured manually or acquired from a DHCP server.
Secondary IP One or more secondary IP addresses and subnet masks for the interface. This value appears only if
Address you configure it.
Helper IP Address The helper IP addresses configured by the command
page 697.
Routing Mode The administrative mode of router interface participation. The possible values are enable or disable.
This value is configurable.
Administrative The administrative mode of the specified interface. The possible values of this field are enable or
Mode disable. This value is configurable.
Forward Net Displays whether forwarding of network-directed broadcasts is enabled or disabled. This value is
Directed configurable.
Broadcasts
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP Displays whether Local Proxy ARP is enabled or disabled on the interface.
M6100 Series Switches
Routing Commands
637
ip helper-address (Interface Config) on