Neighbor Remote-As - NETGEAR M6100 Series Reference Manual

no neighbor prefix-list
This command disables filtering advertisements sent to a specific neighbor based on the
destination prefix of each route.
Format
no neighbor ip-address prefix-list prefix-list-name {in | out}
Mode BGP Router Config

neighbor remote-as

This command configures a neighbor and identifies the neighbor's autonomous system. The
neighbor's AS number must be specified when the neighbor is created. Up to 128 neighbors
may be configured.
Note: The switch does not support a remote-as as-number command in
Peer Template Configuration mode. You must specify the neighbor's
AS number when the neighbor is created.
Default No neighbors are configured.
Format
neighbor {ip-address | ipv6-address [interface interface-name]} remote-as as
number
Mode BGP Router Config
Parameter Description
ip-address The neighbor's IP address. For external peers, this address must be an IP address on the link that
connects the two peers. For internal peers, the neighbor address can be any address, such as the IP
address on a loopback interface. If the neighbor address is an IPv6 link local address, the interface
to the neighbor must be specified using the neighbor update-source command and the IPv6
NEXT_HOP must be explicitly set using the set ipv6 next-hop command in a route map applied
to outbound advertisements to the neighbor.
ipv6-address The neighbor's IPv6 address. If the neighbor's IPv6 address is a link local address, the local
interface must also be specified.
as-number The autonomous system number of the neighbor's AS. The range is 1 to 65,535. If the neighbor's
AS number is the same as the local router, the peer is an internal peer. Otherwise, the peer is an
external peer.
no neighbor remote-as
This command unconfigures neighbors.
Format
no neighbor {ip-address | ipv6-address [interface interface-name]} remote-as
Mode BGP Router Config
M6100 Series Switches
Border Gateway Protocol Commands
830