Ipv6 Dhcp Snooping Limit; Ipv6 Verify Source - NETGEAR M6100 Series Reference Manual

ipv6 dhcp snooping limit

Use this command to control the rate at which the DHCP Snooping messages come on an
interface or range of interfaces. By default, rate limiting is disabled. When enabled, the rate
can range from 0 to 300 packets per second, which is expressed in the pps argument. The
burst level range is 1 to 15 seconds, which is expressed in the seconds argument.
Rate limiting is configured on a physical port and may be applied to trusted and untrusted
ports.
Default disabled (no limit)
Format
ipv6 dhcp snooping limit {rate pps [burst interval seconds]}
Mode Interface Config
no ipv6 dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the
burst level, to the defaults.
Format
no ipv6 dhcp snooping limit
Mode Interface Config

ipv6 verify source

Use this command to configure the IPv6SG source ID attribute to filter the data traffic in the
hardware. Source ID is the combination of IP address and MAC address. Normal command
allows data traffic filtration based on the IP address. With the port-security option, the
data traffic is filtered based on the IP and MAC addresses.
This command can be used to configure a single interface or a range of interfaces.
Default
the source ID is the IP address
Format
ipv6 verify source {port-security}
Mode Interface Config
no ipv6 verify source
Use this command to disable the IPv6SG configuration in the hardware. You cannot disable
port-security alone if it is configured.
Format
no ipv6 verify source
Mode Interface Config
M6100 Series Switches
IPv6 Commands
986