Virtual Router Redundancy Protocol (Vrrp) Commands - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
MAC Address
used by Routing
VLANs
VLAN ID
Logical Interface
IP Address
Subnet Mask
14.4 Virtual Router Redundancy Protocol (VRRP)
Commands
This section describes the commands you use to view and configure VRRP and to view
VRRP status information. VRRP helps provide failover and load balancing when you
configure two devices as a VRRP pair.
Note: The VRRP command is not available on the FSM7328S and FSM7352S
14-18
Is the MAC Address associated with the internalbridge-router
interface (IBRI). The same MAC Address is used by all
VLAN routing interfaces. It will be displayed above the per-
VLAN information.
Is the identifier of the VLAN.
Shows the logical unit/slot/port associated with the VLAN
routing interface.
Displays the IP Address associated with this VLAN.
Indicates the subnet mask that is associated with this VLAN.
switches.
v1.0, October 2008
Routing Commands