Ip Access-List; Ip Access-List Rename - NETGEAR M6100 Series Reference Manual

no access-list
This command deletes an IP ACL that is identified by the parameter
the system. The range for accesslistnumber is 1–99 for standard access lists and
100–199 for extended access lists.
Format
no access-list accesslistnumber
Mode Global Config

ip access-list

This command creates an extended IP Access Control List (ACL) identified by name,
consisting of classification fields defined for the IP header of an IPv4 frame. The name
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
identifying the IP access list. The rate-limit attribute configures the committed rate and the
committed burst size.
If an IP ACL by this name already exists, this command enters IPv4-Access_List config mode
to allow updating the existing IP ACL.
Note: The CLI mode changes to IPv4-Access-List Config mode when you
successfully execute this command.
Format
ip access-list name
Mode Global Config
no ip access-list
This command deletes the IP ACL identified by name from the system.
Format
no ip access-list name
Mode Global Config

ip access-list rename

This command changes the name of an IP Access Control List (ACL). The name parameter
is the names of an existing IP ACL. The newname parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the IP access list.
This command fails is an IP ACL by the name that is defined by newname already exists.
Format
ip access-list rename name newname
Mode Global Config
M6100 Series Switches
Quality of Service Commands
1037
from
accesslistnumber