Mvr Commands; Show Arp Access-List - NETGEAR M6100 Series Reference Manual

Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
Command example:
(NETGEAR Switch) #show ip arp inspection interfaces
Interface Trust State
---------------
0/1
0/2

show arp access-list

Use this command to display the configured ARP ACLs with the rules. Giving an ARP ACL
name as the argument displays only the rules in that ARP ACL.
Format
show arp access-list [acl-name]
Mode Privileged EXEC
User EXEC
Command example:
(NETGEAR Switch) #show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08

MVR Commands

Internet Group Management Protocol (IGMP) Layer 3 is widely used for IPv4 network
multicasting. In Layer 2 networks, IGMP uses resources inefficiently. For example, a Layer 2
switch multicast traffic to all ports, even if there are receivers connected to only a few ports.
To address this problem, the IGMP Snooping protocol was developed. The problem still
appears, though, when receivers are in different VLANs.
M6100 Series Switches
Rate Limit
(pps)
----------- ----------
Untrusted
Untrusted
Switching Commands
Burst Interval
(seconds)
---------------
15 1
10 10
505