Ping Ipv6 - NETGEAR M6100 Series Reference Manual

Field Description
isRtr Shows if the neighbor is a router. If TRUE, the neighbor is a router; if FALSE, it is not a router.
Neighbor State The state of the neighbor cache entry. The possible values are: Incomplete, Reachable, Stale,
Delay, Probe, and Unknown.
Age The time in seconds that has elapsed since an entry was added to the cache.
Type The type of neighbor entry. The type is Static if the entry is manually configured and Dynamic if
dynamically resolved.
Command example:
(NETGEAR Routing) #show serviceport ipv6 neighbors
IPv6 Address
--------------------------------------- ----------------- ----- ---------
------ --------
FE80::5E26:AFF:FEBD:852C

ping ipv6

Use this command to determine whether another computer is on the network. Ping provides
a synchronous response when initiated from the CLI and Web interfaces. To use the
command, configure the switch for network (in-band) connection. The source and target
devices must have the ping utility enabled and running on top of TCP/IP. The switch can be
pinged from any IP workstation with which the switch is connected through the default VLAN
(VLAN 1), as long as there is a physical path between the switch and the workstation. The
terminal interface sends three pings to the target station. Use the ipv6-address or
hostname parameter to ping an interface by using the global IPv6 address of the interface.
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter
is a number in the range of 1–4093.
You can utilize the ping or traceroute facilities over the service or network ports when using
an IPv6 global address ipv6-global-address or hostname. Any IPv6 global address or
gateway assignments to these interfaces causes IPv6 routes to be installed such that the
ping or traceroute request is routed out the service or network port properly. When
referencing an IPv6 link-local address, you must specify the interface keyword with either
the unit/slot/port argument, vlan keyword and vland-id argument, serviceport
keyword, or network keyword.
M6100 Series Switches
MAC Address
5c:26:0a:bd:85:2c FALSE Reachable 0
IPv6 Commands
889
Neighbor Age
isRtr State (Secs) Type
Dynamic