Network Area (Ospf) - NETGEAR M6100 Series Reference Manual

network area (OSPF)

Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of
an interface is covered by this network command.
Default disabled
Format
network ip-address wildcard-mask area area-id
Mode Router OSPF Config
no network area (OSPF)
Use this command to disable the OSPFv2 on a interface if the IP address of an interface was
earlier covered by this network command.
Format
no network ip-address wildcard-mask area area-id
Mode Router OSPF Config
1583compatibility
This command enables OSPF 1583 compatibility.
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in
the routing domain are capable of operating according to RFC 2328,
OSPF 1583 compatibility mode should be disabled.
Default enabled
Format
1583compatibility
Mode Router OSPF Config
no 1583compatibility
This command disables OSPF 1583 compatibility.
Format
no 1583compatibility
Mode Router OSPF Config
M6100 Series Switches
Routing Commands
703