Show Captive-Portal; Show Captive-Portal Status - NETGEAR M6100 Series Reference Manual

Default 300
Format
authentication timeout seconds
Mode Captive Portal Config
no authentication timeout
This command sets the authentication timeout to the default value.
Format
no authentication timeout
Mode Captive Portal Config

show captive-portal

This command reports status of the captive portal feature.
Format
show captive-portal
Mode Privileged EXEC
Term Description
Administrative Shows whether the CP is enabled.
Mode
Operational Status Indicates whether the CP operational status is enabled or disabled.
Disable Reason If CP is disabled, this field displays the reason, which can be None, Administratively
Disabled, No IPv4 Address, or Routing Enabled, but no IPv4 routing interface.
Captive Portal IP Shows the IP address that the captive portal feature uses.
Address

show captive-portal status

This command reports status of all captive portal instances in the system.
Format
show captive-portal status
Mode Privileged EXEC
Term Description
Additional HTTP Displays the port number of the additional HTTP port configured for traffic. A value of 0 indicates that
Port only port 80 is configured for HTTP traffic.
Additional HTTP Displays the port number of the additional HTTPS secure port. A value of 0 indicates no additional
Secure Port port and the default port (443) is used.
M6100 Series Switches
Captive Portal Commands
771