Maximum-Paths (Ospfv); Passive-Interface Default (Ospfv) - NETGEAR M6100 Series Reference Manual

no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
no external-lsdb-limit
Mode Router OSPFv3 Config
maximum-paths (OSPFv3)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform dependent.
Default 4
Format
maximum-paths maxpaths
Mode Router OSPFv3 Config
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back
to its default value.
Format
no maximum-paths
Mode Router OSPFv3 Config
passive-interface default (OSPFv3)
Use this command to enable global passive mode by default for all interfaces. It overrides
any interface level passive mode. OSPF shall not form adjacencies over a passive interface.
Default disabled
Format
passive-interface default
Mode Router OSPFv3 Config
no passive-interface default
Use this command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to nonpassive mode.
Format
no passive-interface default
Mode Router OSPFv3 Config
M6100 Series Switches
IPv6 Commands
939